Heat Treatment Process of Thick Wall Seamless Steel Tube

Date:2023-01-29 Views:225
There are many things that should be paid attention to in the whole heat treatment process of thick-walled seamless steel tubes. For example, the correct setting of the furnace is very important, so as to ensure a smooth cyclone in the furnace, and also make the thick-walled steel tubes receive uniform heat. After that, it can bring very good characteristics. In general, there is no restriction on the ambient temperature during the furnace installation process. In simple terms, it can be a cold furnace or an electric furnace. There are not many limitations in these aspects.

The adoption of the heat treatment process of thick-walled seamless steel tube improves its quality and overcomes the environmental pollution caused by pickling. Let me share with you what is the heat treatment process of thick-walled seamless steel tube?

(1) Roller hearth bright heat treatment furnace

This type of furnace is suitable for heat treatment of large-scale and large-volume thick-walled seamless steel pipes, and the hourly output is above 1.0t. The protective gas that can be used is high-purity hydrogen, decomposed ammonia and other protective gases. It can be equipped with a convection cooling system for faster cooling of thick-walled seamless steel tubes.


thick wall seamless steel tube


(2) Mesh belt type bright heat treatment furnace

This type of furnace is suitable for small-diameter thin-walled precision thick-walled seamless steel tubes. The hourly output is about 0.3-1.0t, and the length of processed steel tubes can reach 40m. It can also process capillary tubes in coils. Equipped with convection cooling system for rapid cooling. Using gaseous fuel or electric heating, various shielding gases can be used. After this type of furnace heat treatment, the thick-walled seamless steel tube has no scratches and good brightness.

(3) Muffle tube bright heat treatment furnace

The thick-walled seamless steel tube is mounted on a continuous bracket and heated in the muffle tube, which can process high-quality small-diameter thin-walled steel tube at a lower cost, and the hourly output is above 0.3t. Protective gas can be used economically, and the heating source can be gas, oil or electricity.
close

We use cookies to offer a better browsing experience, analyze site traffic, and personalize content. By using this site, you agree to our use of cookies.

Accept
Decline